How to Assemble Your ScrapRack
|
1. Unpack your ScrapRack. You will have 3 pieces. Wing A, Base Unit
and Wing B |
Wing A Base Unit Wing B |
|
2. Open the Base Unit on a flat surface. 3. Locate and remove the silver hook. It is located
under the flap. |
5. Insert the silver
hook to secure the legs. Rotate the
hook so that it lays flat on the flap. |
|
|
6. Tip the base unit into it’s normal standing
position, all four rubber
feet on the table, Velcro surface facing you. The long
hinge will be at the top of the base unit. NOTE: If you think your pages are sagging check to be
sure your rack is in this position. |
|
7. Insert the wings. Wing A on the left. Wing B on the right. 8. Before opening a Spinder, press the locking tabs
down to unlock the Spinder. Your
Spinder may need to be realigned after shipment – to do this, unlock, open,
and then close the Spinder. 9. Load the Spinder with storage pages, close the rings
then lock the Spinder before placing the Spinder on the rack. |
CAUTION: Do not remove
spinders from the rack by pulling on the rings. Slide a flat edge
(ruler/pencil) between the velcro surfaces and lift from either end. |
|
10. To lock the
Spinder push the locking tabs up before moving your Spinders on or off the
rack. |
|
4.
Keeping the flap face down on a solid surface, tilt the base unit up creating
an angle and allowing the hinged legs to drop into place on the flap.
